Best Guide For Concrete Polishing
Among the industries that have evolved at a rapid speed is the polishing industry. The companies that are growing and those that are coming up now are too many in this industry. Still other companies will start as most people are getting into this industry. The article has tips that can be applied by the companies to ensure there is good concrete polishing done. These tips are explained in this article.
Determining the surface hardness is the first thing that should be done. Testing the concrete hardness is done with the use of concrete hardness tester. This is to help in deciding on the right abrasives. The tip number nine is the one used for scraping first. Then the scratching is then done in a decreasing order. This continues to a level where the tip cannot do scratching anymore. At this level, the hardness is ok now.
Then the preparation of the concrete surface is done as the next thing. Sometimes one can get the coated floors. Here, the coat is removed with the right equipment. This depend on the type of coating. Some floors may be damaged. It is good to remove the holes and cracks first. Then gritting is done to a level and desired flatness with the metal bond tooling.
The tool marks are then eliminated. This can be done effectively with the use of the transitional tooling. The ability of transitional tooling to eliminate all the marks is high. All the tool marks have to disappear for the tool mark removal process to be considered successful.
Then vacuuming is done to densify and harden the floor. The pore and crack filer is used to densify and solidify the surface of the floor. It helps avoid water penetration that can result in stains that can result due to water penetration. The pooling of the floor can result hence care should be taken to prevent it from happening. This is because the stains caused by poling can result to the stains that can make polishing hard to do.
Then now the polishing is done after all the above things are complete. One is advised to start with the resign band. Then all the dust is removed that is, the space is vacuumed in between the passes. Then the floor is burnished with a burnishing pad after the final grit level is achieved.
Then for protecting is done as the last thing. The floor is sealed so as it can be protected. This will protect the surface from things like grease, oil, and any other chemicals. The sealer can be applied with the use of a pump and allowed to coat. To leave the floor shining, burnishing is essential. Successful concrete polishing can be done with the tips given.